Second issue is the real issue- When using WDS AP and WDS STA mode along with a UL/LU channel, the STA will only connect at HT20 speed. (Clarification still necessary if only on 2.4ghz, 5ghz or both). UU and LL in WDS AP and WDS STA mode works fine from what I read at the top. This is a bug for sure and I agree.

May 10, 2020 · DD-WRT is an open-source router firmware upgrade project created to enhance the performance and features of consumer wireless routers. It is used by many networking-savvy users to enhance wireless router stability, privacy, and (most importantly) network security. DD-WRT has been impressing users since its inception in 2005, and is the go-to alternative router firmware due to its longevity of existence and support of the largest array of devices. Consequently, DD-WRT can claim the largest community of users. It's the backbone of what we do here at FlashRouters. A Wireless Distribution System, or WDS, is a cheap and easy way to extend your wireless network coverage. It’s cheap, because you can set up a couple of sub-$60 routers with the open-source firmware DD-WRT , including the Linux-powered Linksys WRT54GL (only $56 these days on Amazon.com ) and other compatible routers. Second issue is the real issue- When using WDS AP and WDS STA mode along with a UL/LU channel, the STA will only connect at HT20 speed. (Clarification still necessary if only on 2.4ghz, 5ghz or both). UU and LL in WDS AP and WDS STA mode works fine from what I read at the top. This is a bug for sure and I agree. A wireless distribution system (WDS) is a system enabling the wireless bridging of access points in an IEEE 802 network. It allows an extended network to be created using wireless IEEE 802.11 access points without the traditional requirement for wires to link them.

For WDS instructions click on the "WDS" in my signatureI wrote some detailed instructions on how to set up WDS; just change from WL0 to WL1 and it should work the same. I have not tested it as I don't have 2 5GHz routers at this location but don't see any reason it should not work the same way.

A Wireless Distribution System, or WDS, is a cheap and easy way to extend your wireless network coverage. It’s cheap, because you can set up a couple of sub-$60 routers with the open-source firmware DD-WRT , including the Linux-powered Linksys WRT54GL (only $56 these days on Amazon.com ) and other compatible routers.

For WDS instructions click on the "WDS" in my signatureI wrote some detailed instructions on how to set up WDS; just change from WL0 to WL1 and it should work the same. I have not tested it as I don't have 2 5GHz routers at this location but don't see any reason it should not work the same way.

Feb 19, 2018 · How To Set Up A Repeater Bridge On Your DD-WRT Router. To begin, make sure that the main router has a 192.168.1.X subnet and leases a DHCP address in the same pool. The secondary router must be running DD-WRT. To ensure easy setup, always click Save and not Apply between steps. Reset to Factory Defaults on the secondary DD-WRT router. Enabling this security feature on one’s DDWRT VPN router is very easy. First, navigate to the DDWRT control panel (usually 192.168.1.1). Click the “Administration” tab, then click the “Keep Alive” tab. Under WDS/Connection watchdog select enable. For interval, 360 seconds is a great interval to check for connectivity. DD-WRT.tsk: 45.33 KB: 2005-07-15: gpl.txt: 17.59 KB: 2006-03-27: Latest DD-WRT Releases. To obtain the matching version for your router please use the Router Database: